Tickets :: Comment on [#167] Registration::createAccount() fails against openfire

* Your Email Address
* Spam protection	Enter the letters below: __ ___ ________ _ _ \ \ / \ \ / /___ / \| \| \| \| \ \ /\ / / \ \ /\ / / / / \| \| \| \| \ \/ \/ / \ \/ \/ / / / _ \| \|_ \| \| \ /\ / \ /\ / / /__ \|__\| \| \|__\| \| \/ \/ \/ \/ /_____\____/ \____/
Comment	> Registration::createAccount() fails with "bad-request" when using > gloox version 1.0, but the same call works fine when using gloox > 0.9.9.12. > > I am not sure if this is a gloox regression issue or if this is an > Openfire problem. > > Perform the following steps: > 1) Install Openfire version 3.6.4. Configure Openfire to allow > creation of new accounts anonymously > 2) Using a jabber client (such as Spark), verify a new account can be created > 3) Using the gloox 1.0 library, write a small program to create a new > account, as described in the gloox/registration.h file > 4) Run the program ==> Openfire fails to create the account. The > response sent back to gloox states "bad-request" > 5) Now adapt the same program to work with gloox 0.9.9.12. Launch the > program to create a new account ==> account registration is > successful. > > The program uses something very basic as described in the documentation: > m_client = new Client( "a.b.c.d" ); > m_client->disableRoster(); > m_client->registerConnectionListener( this ); > m_reg = new Registration( m_client ); > m_reg->registerRegistrationHandler( this ); > m_client->connect(); >
Attachment
Watch this ticket